D- Using Your Product - Ugur UMD 200 HS Manual Del Usuario

D- USING YOUR PRODUCT

Start-up
WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up. (see page 19).
• If your product has been shaken so much during the transportation and positioning, wait for three (3) hours
without running it. Thus, the compressor oil, which may enter into the system, will return back. You may
damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 11)
• Take the compressor and lamp buttons to on (I) position (Figure 12)
• You will hear a slight sound from the compressor when your product is running.
PICTURE 11
Setting the Internal Temperature of your Cooler
Internal temperature of your device has been factory set in a manner that it will protect your food
without causing them spoiled.
Preservation temperature of the products can be adjusted by means of an electronic thermostat on
your device
Set value of your device has been adjusted at the production plant. This value is the value that can
protect the products inside of your device without spoiling under any conditions.
When you run your product at factory set value, you get the best result in terms of both the perfor-
mance and energy consumption.
Run your device empty for at least three (3) hours. Therefore inside of your product will be cooled
down in the best way.
PICTURE 12
43
EN