Ugur UMD 200 HS Manual Del Usuario página 48

E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
COOLER
CLEANING
Cleaning of your device is composed of two stages, which are the internal cleaning and external cleaning.
Following warnings must certainly be abided before start cleaning.
CAUTION!
Unplug your product before every cleaning.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Never use domestic cleaning agents, abrasive and scratching substances (surface cleaners, detergent,
flammable and sparkling, solvent like gasoline, thinner, acid) as cleaning agents. Otherwise loosening
may occur in the plastic parts of your product.
Never use flowing and pressurized water for cleaning.
Internal cleaning
Transfer the foodstuff inside your product to a convenient place.
Before the internal cleaning, wait until the temperatures of the internal parts of your product reaches to
the ambient temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Remove the accessories from inside.
EN
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents recom-
mended by Uğur Soğutma A.Ş.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three (3) hours after running your product as stated in this manual.
External cleaning
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section while cleaning.
Clean the door gasket by using clean soapy water only.
Maintenance
This product does not require periodical maintenance.
SUGGESTION
You can use Uğur branded cleaning agents, which you can get from Authorized Uğur Services for
internal and external cleaning of your device.
48