Inserting Batteries; Remote Control - Revell Control JUNIOR Manual De Instrucciones

remote control. Single-use batteries
for this remote control and other
electrical devices operated in the
home can be replaced with environ-
mentally-friendly rechargeable
batteries.
• Batteries must be inserted according
to the correct polarity (+ and -).
• Depleted batteries must be removed
from the remote control.
• The connection terminals may not
be short-circuited.
Maintenance and care:
• Please only use a clean, damp cloth
to wipe off the model.
• Protect the model and batteries from
direct sunlight and/or direct heat.
• Never allow the remote control to
come into contact with water,
because the electronics can be
damaged as a result.
• Technical changes and differences
in colour reserved!
Battery requirement for
the remote control:
Power supply:
Batteries: DC 9 V;
1 x 9 V E-Block 6LR61
(not supplied)
Battery requirement for
the vehicle:
Power supply:
Batteries:
DC 6 V; 4 x 1,5 V AA
(not supplied)
1 VEHICLE
1A Straight-ahead trimming
1B Battery compartment securing screw
1C Battery compartment safety lever
1D ON/OFF switch

2 REMOTE CONTROL

2A forwards / backwards
2B right / left
2C Antenna

3 INSERTING BATTERIES

Remote Control
3A Carefully remove cover.
3B 1 x 9 V E-Block 6LR61 and pay
attention to the polarity, as shown
in the battery compartment.
3C Close the battery compartment.
Model
3D Unscrew and remove the cover.
3E Insert 4 x 1.5 V AA batteries,
paying attention to the polarity
as shown in the battery
compartment.
3F Close the battery compartment
cover and tighten the screw.
19