INSTRUCTIONS FOR USE
Indication for use:
The Arm / Hand and Minor Procedures Tables are used in a variety of surgical
procedures including, but not limited to arthroscopic or open Orthopedic surgery.
These devices are capable of being used with a broad patient population as
determined appropriate by the caregiver or institution.
Intended use:
The Arm / Hand and Minor Procedures Tables are designed to position, support
and/or distract the patient's hand, wrist, forearm and arm in a variety of surgical
procedures including, but not limited to arthroscopic or open Orthopedic surgery.
These devices are intended to be used by healthcare professionals within the
Operating Room setting.
Residual Risk:
This product complies with relevant safety standards. However device harm from
misuse, device damage, malfunction or biological hazards cannot be completely
excluded.
3. Equipment Setup and Use:
Prior to use:
a. Inspect the product looking for any visible damage or sharp edges that could be
caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.
Setup:
1. Place the two rail clamps on the surgical table's back section rail approximately
12", 30cm, apart on the patient's affected side.
2. Hold the table vertically above the rail clamps with the frame braces outboard
of the surgical table and the Mounting Posts pointing toward the open slots of the
rail clamps.
3. Lower the post into the clamps & tighten the rail clamp locking knobs.
Document Number: D-720113
Version: C
Page 12
Issue Date: 26 MAR 2020
Ref Blank Template: 80025117 Ver. F