Technical Parameters - Toya POWER UP 78970 Manual De Instrucciones

PROPERTIES OF THE TOOL
The drill and screwer is a universal portable tool which does not require external power supply for do-it-yourself enthusiasts
designed to drill holes in distinct materials (e.g. wood and wood-derived materials, metals) and to screw and unscrew bolts. Its
special advantages will be appreciated by DIY enthusiasts realising assembly and finishing jobs. The tool has been designed
solely for domestic work and must not be used professionally, i.e. in workshops and for remunerable jobs. A correct, reliable and
safe functioning of the electric tool depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The device is supplied complete and does not require assembly. The drill and screwer is supplied along with a battery, a charging
dock, a power pack for the charging dock, as well as drill and screwdriver bits.

TECHNICAL PARAMETERS

Parameter
Catalogue number
Operating voltage
Rotation (idle)
Maximum torque
Noise level
- acoustic pressure
- LWA power
Protection grade
Insulation class
Level of vibration (drilling / screwdriveting)
Mass
Tool handle
Battery
Battery capacity
Power pack
Input voltage
Mains frequency
Output voltage
Output current
Charging duration
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do not
work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours. Elec-
tric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours. Do not allow children
and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock. Avoid
contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk of an
O R I G I N A L
GB
Unit of measurement
[V]
[min ]
-1
[Nm]
[dB]
[dB]
[m/s ]
2
[kg]
[mm]
[mAh]
[V]
[Hz]
[V]
[mA]
[h]
I N S T R U C T I O N S
Value
78970
10,8 DC
0 - 350 / 0 - 1300
16
66,9 ± 3,0
77,9 ± 3,0
IP20
III
0,473 ± 1,5
0,8
0,8 - 10
Li-ion
1300
~230
50
12,6 DC
1500
1
11