Commissioning; Using The Glass Ceramic Hob; Solid Top Range Hob; Reminders For Replacing Components - AFG 700 Serie Instrucciones Para Instakkacion, Uso Y Manteniniento

Connect the metal structure of the appliance to the equipoten-
tial node. Connect the conductor to the terminal with the
symbol on the outside part of the bottom.
9.4 CONNECTION TO THE WATER SUPPLY
The appliance must be connected to a potable water supply.
The water inlet pressure must be between 150 kPa and 300
kPa. Use a pressure reducer if the inlet pressure is above the
maximum permitted level.
• Install a mechanical filter and a shut-off valve upstream of the
appliance in an easily accessible point.
• Make sure the water circuit is free from ferrous particles befo-
re connecting the filter and the appliance.
• Seal any unused connectors with a plug.
• Once the appliance has been installed, check for gas leaks at
the connection points.
9.5 CONNECTION TO THE WATER DRAIN
The water drainage system must be provided using materials
resistant to temperatures of 100 °C.The bottom of the applian-
ce must not be subjected to steam produced by drainage of hot
water.Install a siphoned floor drain with grating below the water
drain cock of Boiling pans and in front of Bratt pans.

10 COMMISSIONING

See Chapter " INSTRUCTIONS FOR MAINTENANCE "
INSTRUCTIONS FOR USE
REMINDERS FOR THE USER
The manufacturer will not be liable for any damage or in-
jury resulting from failure to observe the following rules
• Read this manual carefully. It provides important information
for safe installation, use and maintenance of the appliance.
• Keep this manual in a safe place known to all users so that it
can be consulted throughout the working life of the appliance.
• Installation, conversion to a different type of gas and applian-
ce maintenance must be carried out by qualified technicians
authorized by the manufacturer, in compliance with current
safety standards and the instructions in this manual.
• For after-sales service, contact technical assistance centers
authorized by the manufacturer and demand the use of origi-
nal spare parts.
• Have the appliance serviced at least twice a year. The manu-
facturer recommends taking out a service contract.
• The appliance is designed for professional use and must be
operated by trained personnel.
• The appliance is to be used for cooking food as specified
in the reminders for use. Any other use must be considered
improper
• Do not allow the appliance to operate empty for prolonged
periods. Only pre-heat the oven just before use.
• Do not leave the appliance unattended while in operation.
• In the event of an appliance fault or malfunction, shut the
gas shut-off valve and/or switch the appliance off at the main
switch installed upline.
• Clean the appliance following the instructions given in Chap-
ter " INSTRUCTIONS FOR CLEANING".
• Do not store flammable materials in close proximity to the
appliance. FIRE HAZARD.
• Children should be supervised to ensure that they do not play
with the appliance.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
24
ties, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Do not obstruct any air vents or drains present on the ap-
pliance.
• Do not tamper with appliance components.

11 USING THE GLASS CERAMIC HOB

Important: Use flat-bottomed pots and pans having a diame-
ter that is suitable for the cooking zone. The bottom of pots
and pans must be clean, smooth and dry in order to avoid
scratching the surface of the glass ceramic hob. Do not place
aluminium foil or plastic containers on the hot surface of the

glass ceramic hob.

In any case, the glass ceramic hob must not be used as rest
surface.
SWITCHING ON AND OFF
The radiant hotplate control knob has the following positions :
0 Off
1 Minimum temperature (S.700/900)
2 ÷9 (S.900) 2 ÷5 (S.700) Intermediate temperatures
10 (S.900) 2 ÷6 (S.700)
Switching on
• Turn the knob for the corresponding cooking zone to the desi-
red setting.Important:The indicator light on the control panel
turns on when the temperature of the cooking zone is above
50°C.
Switching off
• Turn the knob to position " 0 ".
12 USING THE SOLID TOP RANGE HOB
REMINDERS FOR USE
• The appliance is designed for cooking foods contained in
pots and pans.
• Use flat-bottomed pans.On the wok must be use the specific
pans.
• Do not leave the hotplates switched on with no pan or an
empty pan in place.
• Do not pour cold liquids onto the hot hotplate.
• Do not install the appliance on hot elements.
SWITCHING ON AND OFF
The thermostat control knob has the following positions:
0 Off
50-400°C Cooking temperatures
Switching on
• Turn the knob to the chosen temperature setting for cooking.
• The yellow indicator light switches on.
Switching off
• Turn the thermostat knob to position "0".
• The yellow indicator light switches off when all the hotplates
are switched off.
Maximum temperature