Cleaning And Maintenance - cecotec Ready Warm 10100 Smart Ceramic Manual De Instrucciones

ENGLISH
temperature is 4 ºC below the set one.
• The appliance will automatically switch to low-power heating when the room temperature
is between 0 and 2 ºC below the set one.
• The appliance will automatically turn off when the room temperature is above the set
one. The fan will operate for 30 seconds in order to cool down the device and will then
switch to standby mode. If the room temperature falls 2 ºC below the set one, it will
automatically turn on again.
3. Press to turn the device off. The fan will operate for 30 seconds before turning com-
pletely off.
4. SAFETY TIP-OVER SWITCH
The heater is designed to turn automatically off when tipped forward or backward. The unit
will automatically turn on once it is returned to its normal upright position.
OVERHEAT-PROTECTION SYSTEM
This heater is protected with an overheat protection that switches off the appliance automa-
tically in case of overheating, for example due to the total or partial obstruction of the air inlet
or outlet. In this case:
1. Unplug the appliance and wait about 30 minutes for it to cool down.
2. Remove the object which is obstructing the air inlet or outlet.
3. Switch it on again. The appliance should now operate normally.
REMOTE CONTROL AND BATTERY
Note: the remote control requires 1 x CR2025 3V lithium battery (not included).
1. Open the battery compartment by sliding the cover down.
2. Insert the battery into the compartment, observing the polarity in the diagram (see below
drawing).
3. Close the battery compartment.
WARNING: keep batteries out of reach of children

5. CLEANING AND MAINTENANCE

• Always turn off, unplug and allow the appliance to cool down before cleaning.
• Do not use abrasive scouring pads, powders or cleaners to clean the product.
14 READY WARM 10100 SMART CERAMIC
Close Open
Push