Torque Calibration - Desoutter ELS pistol tools E-LIT PREMIU Serie Manual Del Usuario

English
BRIEF DESCRIPTION
A
See page 8.
Legend
1 Ventilator slots
2 Reporting bar
3 Torque calibration opening
4 Ring
5 High-intensity LED
6 Trigger
7 To remove the battery pack
8 Battery pack
9 Reverse button
INSERTION OF THE BATTERY PACK
B
See page 8.
The battery screwdriver is ready to operate as
soon as a loaded battery is mounted on the tool.
There is no On/Off switch.
REMOVING THE BATTERY PACK
C
See page 8.
HOW TO START THE TOOL
D
See page 8.
Any time the trigger is pressed, the high-intensity
LED will light.

TORQUE CALIBRATION

E
See page 9.
The tool has a tamper proofed calibration: a
black cover protects the clutch mechanism from
unvolontary action.
For safety reasons, always remove
the battery before proceeding with
the calibration.
1. Turn the bright screw 90° and the black cover
will open and the clutch will be visible.
2. Use the clutch adjustment key to turn the
clutch to the position where the adjustment
hole is visible.
3. Use the clutch adjustment key to increase or
reduce the torque ("+" and "-" appear on the
calibration tool).
4. Close the cover again.
EXCHANGING SCREWDRIVER BITS *
F
See page 9.
* According model.
The new bit is automatically locked when
you release the ring.
09/2019
NOW THE TOOL IS READY FOR
TIGHTENING
Start tightening
G
See page 9.
After each tightening, the battery screwdriver
displays result information.
IMPORTANT: No result information is
displayed when operating in the reverse
mode.
Rehit protection
H
See page 9.
If the tool should be applied to an already
tightened screw, the clutch immediately operates
and there will be no significant tightening angle.
BUZZER
Disable
I
See page 10.
Enable
J
See page 10.
REVERSE ACTIVATION
K
See page 10.
TWO REVERSE MODES
L
See page 10.
Legend
L1 Mode 1: one touch reverse (default)
L2 Mode 2: Permanent reverse
BATTERY CHECK
M
See page 11.
LOW BATTERY STATUS AFTER EACH
TIGHTENING
N
See page 11.
SPEED SETTING MODULE - V2
O
See page 11.
ANGLE HEAD ADJUSTMENT
P
See page 14.
ZIGBEE® NETWORK CONNECTION
(FOR ELC-Z TOOLS)
Q1
See page 15.
19 / 130
6159931420_23