turbionaire SENSO 20 Manual De Instrucciones página 5

A. OPERATIONAL PRECAUTIONS
WARNING: to reduce the risk of fire, electric shock or injury to persons or property:
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
•
The A-weighted sound pressure level is below 36 dBs.
• The appliance shall be disconnected from its power source during maintenance.
•
Always operate the unit from a power source of equal voltage, frequency and rating as
indicated on the product identification plate.
•
Always use a power outlet that is grounded.
•
Unplug the power cord when cleaning or when not in use.
• Do not operate with wet hands. Prevent water from spilling onto the unit.
•
Do not immerse or expose the unit to rain, moisture or any other liquid.
•
Do not leave the unit running unattended. Do not tilt or turn over the unit.
• Do not unplug while the unit is operating.
•
Do not unplug by pulling on the power cord.
•
Do not use an extension cord or an adapter plug.
•
Do not put objects on the unit.
•
Do not climb or sit on the unit.
•
Do not insert fingers or other objects into the air outlet.
•
Do not touch the air inlet or the aluminum fins of the unit.
•
Do not operate the unit if it is dropped, damaged or showing signs of product
malfunction.
•
Do not clean the appliance with any chemicals.
•
Ensure the unit is far away from fire, inflammable, or explosive objects.
• The unit shall be installed in accordance with national wiring regulations.
•
Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacture.
•
The appliance shall be stored in a room without continuously operation sources (for
example: open flames, an operating gas appliance or an operating electric heater).
• The appliance shall be stored so as to prevent mechanical damage from occurring.
•
Do not piece or burn, even after use.
•
Be aware that refrigerants may not contain an odor.
• Pipe-work shall be protected from physical damage and shall not be installed in an
unventilated space, if that space is smaller than 4m².
•
Compliance with national gas regulations shall be observed.
•
Keep any required ventilation openings clear of obstruction.
•
The appliance shall be stored in a well-ventilated area where the room size corresponds
to the room area as specified for operation.
Any person who is involved with working on or breaking into a refrigerant circuit
should hold a current valid certificate from an industry-accredited assessment
5