YATO YT-85080 Manual De Instrucciones página 20

GB
Transport of the batteries
Lithium-ion batteries are in accordance with legal regulations treated as dangerous waste. The user of the tool may transport the
tool with the battery or only batteries by land. Then no additional conditions must be complied with. In transport is realised by third
parties (for example dispatch through courier service), then it is required to proceed in accordance with regulations for transport
of dangerous materials. Before shipment, contact an authorised person.
It is prohibited to transport damaged batteries. During transport the battery must be removed from the tool, and the exposed
contacts protected, e.g. with insulating tape. Protect the batteries so that they do not move inside the package during transport. It
is also required comply with the national regulations for transport of dangerous materials.
Charging the battery
Attention! Before charging you should disconnect the charger from the mains by unplugging the power supply from the mains. In
addition, you should clean the battery and its terminals of dirt and dust with a soft, dry cloth.
Disconnect the battery from the tool.
Insert the battery in the charger socket (XV),
The charging station has two LEDs, green and red. They show the status of operation:
- the red LED lights up - the charging station connected to the power supply,
- the green LED lights up - the battery is charged,
- the red LED lights up, a green LED is flashing – charging the battery,
- red and green LEDs are flashing at the same time - the temperature protection is on,
- red LEDs is flashing - the battery is damaged,
Plug the charger into a mains socket.
Unplug the charger from the mains outlet after the charging is finished.
Pull out the battery from the charging station. You should pull out the battery from the charging station immediately after the end of
charging process. Leaving the battery in the mains connected power charging station may result in its irreversible damage..
The charging station and/or the battery may become warm during charging. This is normal. When you are loading the battery in
a high temperature environment the temperature protection in charger can switch on. The charging process is interrupted until
the cooling of electronic systems of station, after that it is automatically resumed. In such conditions, the battery charging time
will be longer.
MAINTENANCE AND STORAGE OF THE PRODUCT
Attention! Before starting any operation, which is described below, you should disconnect the chain saw from the power supply.
Chain saw, which are mains powered, should be disconnected from the wall outlet, the chain saw, which are battery operated,
should be disconnect from the battery.
After each use, you should examine the chain saw condition, with a focus on the patency of ventilation openings.
Check the alignment of all elements of the chain saw. Any loose connections should be tightened. Check the voltage and condition
of the chain. If you notice any chain damage, the chain should be replaced with a new one. It is forbidden to operate the chain
saw with a damaged chain.
Too loose chain may fall out from its guide, which can cause injury to a person that operates the chain saw. The chain must also
be properly sharpened, because it requires the relevant experience and tools, it is recommended, to perform chain sharpening
in a specialist service. You should fill up the oil deficiencies in the tank. The chain saw housing should be cleaned with a soft dry
cloth. Clean the housing of residual wood, oil, grease and other contaminants. The chain saw should be stored in a dry, closed
room, disconnected from the mains.
Attention! During storage, the chain saw may produce a small amount of oil from the chain lubrication system, this is normal and
does not affect the oil level in the tank and is not a sign of failure.
The chain saw should be stored in the areas, which are shaded dry, and equipped with adequate ventilation to prevent conden-
sation. The place should not be available for bystanders, especially children. During storage the guide and chain should always
be protected by the cover.
O R I G I N A L I N S T R U C T I O N S
20