Re-Synchronize The System - Petsafe Guardian GIF-275-11 Guía Para El Uso

Re-synchronize the System

1. Remove the Receiver Collar from your pet.
2. Remove the battery from the Receiver Collar. Discharge all power
by holding the correction level button down until the LED is no
longer illuminated.
3. At the transmitter, move the Boundary Switch/Range from the low
to the high position.
4. Adjust the Boundary Control Dial up to 8, down to 1 and then
back to the #4 position.
5. Standing within 5-10 feet of the Transmitter, reinsert the battery
into the Receiver Collar.
6. Test the Boundary and verify operation by walking out into the Pet
Area until your Receiver Collar responds. (With the Transmitter set
to 4, it should activate approximately 40-50 feet away).
Once you are confident that the system is working, reset the
Transmitter controls to the original setting.
22 1-800-732-2677