Rockwell RK5132K Manual Del Usario página 8

OSCILLATING TOOL
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Assembly and Operation
Action
Mounting Accessories
Mounting the Sanding Sheet
Operating the On/Off Switch
Using the Variable Speed Dial
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories used
and the respective application.
Oscillation
frequency
High oscillation
frequency
Low oscillation
frequency
WORKING HINTS FOR YOUR TOOL:
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds. Always keep the
blade sharp.
Always ensure the workpiece is firmly held or clamped
to prevent movement.
Any movement of the material may affect the quality of
the cutting or sanding finish.
Start your tool before working and turn it off only after
you stop working.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away , it will
damage the sanding pad. The guarantee does not cover
sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces and fine grit for finishing
surfaces. If necessary, first make a test run on scrap
material.
Excessive force will reduce the working efficiency and
cause motor overload. Replacing the accessory regularly
will maintain optimum working efficiency.
8
Figure
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
Application
Sanding, sawing, rasping and
polishing stone and metal.
Scraping, polishing varnishes.
MAINTAIN TOOLS WITH CARE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ENG