Rockwell Sonicrafter RK2863K Manual Del Usuario página 7

20V Cordless osCillating tool
oPeration instrUCtions
note: Before using the tool, read the instruction book
carefully.
1. moUnting aCCessories
CaUtion: For all work or when changing accessories,
always wear protective gloves and make sure battery is
removed. avoid danger of injury from the sharp edges of the
accessories. accessories can become very hot while working,
presenting danger of burns!
Warning: to reduce the risk of injury, do not let the
sharp side of the accessory face back toward the user's
hand.
the hyperlock™ tool-free system allows you change the
accessories without using an allen key.
- Flip the Hyperlock™ Accessory Clamping Lever forward
to the open position. (See Fig A)
- Rotate the Lever counterclockwise to loosen the Flange.
- Insert the accessory onto the Universal-Fit
then press down the Flange with finger to keep blade
temporarily secure. (See Fig. B)
- Rotate the Lever clockwise until accessory is tightened
Securely. (See Fig. C)
- Flip lever back down to seated position.
note: For prior model Rockwell Sonicrafter hex-interface
accessories and most other non-Rockwell branded accessories,
the Flange must be completely removed to install
accessory. (See Fig. D)
2. moUnting / Changing the sanding sheet (see Fig. e)
Align the sanding sheet and press it onto the sanding pad by hand.
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it 120°
and place it on again.
note: For other various brands, use smaller flange provided.
Accessory Interface,
TM
eng
A
1
2
B
1
2
C
D
E
7