Rockwell Sonicrafter RK2863K Manual Del Usuario página 9

20V Cordless osCillating tool
disPosal oF an eXhaUsted batterY
PaCK
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains Lithium
batteries. Consult your local waste authority for information
regarding available recycling and/or disposal options. Discharge
your battery pack by operating your drill, then remove the battery
pack from the drill housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the components.
WorKing hints For YoUr tool
If your power tool becomes too hot, especially when used at low
speed, set the speed to maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged usage at very low speeds.
Always keep the blade sharp.
Always ensure the workpiece is firmly held or clamped to prevent
movement.
Any movement of the material may affect the quality of the cutting or
sanding finish.
Start your tool before working and turn it off only after you stop
working.
Do not start sanding without having the sandpaper fitted.
Do not allow the sandpaper to wear away , it will damage the sanding
pad. The guarantee does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit for smooth
surfaces and fine grit for finishing surfaces. If necessary, first make a
test run on scrap material.
Excessive force will reduce the working efficiency and cause motor
overload. Replacing the accessory regularly will maintain optimum
working efficiency.
maintain tools With Care
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
eng
9