LifeWave BST Manual Del Usuario página 18

EMC Parameters
Guidance and manufacturer's declaration for electromagnetic
compatibility (EMC) for the LifeWave BST according to
EN 60601-1-2:2007
Guidance and manufacturer's declaration – electromagnetic emissions – LifeWave BST
The LifeWave BST is intended for use in the electromagnetic environment specified below; the
customer or the user of the LifeWave BST should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity – LifeWave BST
The LifeWave BST is intended for use in the electromagnetic environment specified below; the
customer or the user of the LifeWave BST should assure that it is used in such an environment.
Immunity IEC 60601
test Test level
±6 kV
Electrostatic
contact
discharge
(ESD) IEC
61000-4-2
±8 kV air
146
Table 1
Compliance Electromagnetic environment - guidance
The LifeWave BST uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
Group 1
not likely to cause any interference in nearby electronic
equipment.
Class B
The LifeWave BST is suitable for use in all establishments,
Class A
including domestic establishments and those directly
connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Complies
Table 2
Compliance
level
±6 kV
contact
±8 kV air
© All Right Reserved, LifeWave Ltd. 2010
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30%.