Specifications - SpeedClean FLOWJET-60 Instrucciones De Operacion Y Mantenimiento

FlowJet-60
Motor/ Power Requirements (115 V Model)
Motor/ Power Requirements (230 V Model)
Water Requirements
Maximum Inlet Water Pressure
Maximum Output Water Pressure
Weight
Maximum Inlet Water Temperature
Maximum Ambient Operational Temperature
Troubleshooting
PROBLEM
Inconsistent and/or
erratic pressure
Motor stops abruptly
Motor buzzes but fails to start
Unit does not spray chemical
Accessories/Spare Parts
Accessory/Spare Part
15° Cleaning Nozzle (Yellow)
25° Cleaning Nozzle (Black)
Spray Gun Assembly (with 18" Lance Attached)
Primary Hose Assembly – Connects to Pump (12 ft)
Extension Hose Assembly (12 ft)
Spray Gun Assembly without Lance (optional)
18" Extension Wand (optional)
40" Condenser Needle — Sectional Two Piece (optional)
Replacement Water Seal Kit for Pump
© 2018 All Rights Reserved.

Specifications

PROBABLE CAUSE
• Nozzle clogged
• Inadequate water supply
• Motor thermal
breaker tripped
• Inadequate power supply
• Siphon injector clogged
• Pickup hose not in chemical
3/4 HP AC Motor (1φ) / 115 VAC / 12.5 Amps
1 HP AC Motor (1φ) / 230 VAC / 5.7 Amps
2.5 Gallons per Minute (2 GPM 50 Hz)
100 PSI (6.8 BAR)
400 PSI (27.2 BAR)
35 lbs
125°F (52°C)
104°F (40°C)
REMEDY
• Clean nozzle orifice
• Ensure 2.5 GPM minimum
• Turn off, let unit cool
• Check for proper
voltage/current
• Inspect and clean siphon
• Put hose to bottom
of chemical
Part #
CJ-QDN-1508Y
CJ-QDN-LP25
CJ-RCC-23
CJ-RCC-13
CJ-HF-EXTHOSE
SC-RCC-14
CJ-9655
SC-WWSS-HF
RCC-09-SK
5