Operation And Function; Meter, Lux, Time Knob - Boer Temper Koban KDP9 360 mini Manual Del Usuario

NOTE
Adjust detectors position and secure bottom of is stuck firmly on ceiling
(FIG.17). Recheck and wipe slightly with a dry clean cloth if detector surface is
dirty.
Restore power supply.
Detector
Operation and
function
NOTE
Test mode: Turn the arrowhead
of"TIME"knob pointing at "Test"
to enter into test mode. Both of
the connected lighting device and
detector LED will be switched on for
2sec once the movement is detected.
mode: Detector can control the
staircase timer by using this mode.
When the detector is triggered by
movement, its combined staircase
timer will be switched on and load of
staircase timer is turned on. The load
will turn off when the time setting of
staircase timer is reached.
TIME and LUX knob must be set
at right position of value figure
marked. DO NOT set knobs between
two value figures to avoid value
confusion. i.e. if the desired value
www.grupotemper.com
Power box
Only suitable for ceiling board of
thickness between 5mm and 20mm
FIG.17
Mini presence detector
is 1000LUX, but the knob was
positioned in between 1000LUX and
, the performance value would be
either 1000LUX or infinite.

METER, LUX, TIME Knob

Follow the marked values to adjust
METER, LUX, TIME knob according to
users desires (See FIG.18).
METER
100 400
1m.
1s.
30 1000
10 Test
LUX
CONTROL L↓ CONTROL L↓
FIG.18
Instructions manual |
KDP9
5m.
10m.
15m.
TIME
25