Test Mode; Walk Est - Boer Temper Koban KDP9 360 mini Manual Del Usuario

KDP9
Mini presence detector
METER knob setting
• Set METER knob value at the
position of "-" for the smallest
"field of view"
• Set METER knob value at the
position of "+" for the largest
"field of view".
• Set METER knob value at the
position between "-" and
"+"for "desired field of
view".
LUX knob setting
6 precise Lux adjustments for
selection: 10/30/100/400/1000/
Turn LUX knob to "
be switched on at any light level.
Auto off precise time adjustment
TIME (L ): Test /
/ 15m. (6 Adjustments).

Test mode

LED function
• A red LED is built-in for KDP9,
when detector is triggered, it will
turn on for approx. 2sec for clear
operation (See FIG 19) KDP9
does not has LDE indicator.
• LED as an indicator acts in
warming up period,test mode
and also while trggering the
detector.
Instructions manual |
", load will
/ 1m. / 5m. / 10m.
26
Red LED
FIG.19
Walk test
The purpose of the walk test is to
select a proper installation place and
gain the desired detection coverage.
Turn METER knob to "+", LUX knob
to " ", TIME knob to "Test",
then conducting a walk test referring
to step 4.1 and Lux is disable under
test mode.
NOTE
It takes approx. 60sec to warm up
after power is supplied, then enters
into normal operation to carry out a
walk test.
FIG.20
www.grupotemper.com