Trouble Shooting - Boer Temper Koban KDP9 360 mini Manual Del Usuario

KDP9
Mini presence detector

Trouble shooting

When KDP9 works abnormally, check
assumptive problems and suggested solutions in following
table that will hopefully to solve your problem.
Problem Possible cause
Lighting 1.Power does not turn on.
device does 2.Wired incorrectly.
not turn on 3.Knob adjusted incorrectly.
4.Malfunctioned load.
Lighting 1. Incorrect time setting
device does 2.Detector is nuisance
not turn off triggered.
3. Wired incorrectly.
LED does not 1.The detection range is
turn on exceeded.
2.No power supplied.
3."TIME" knob setting
isn't on"Test".
4.Wired incorrectly.
Instructions manual | 28
Suggested solution
1.Switch on the power.
2.Refer to wiring diagrams
(FIG.8-FIG.9) and check if
the load is malfunctioned.
3.Check if knobs are set to
the correct position, then
supply the power to check
if the LED will turn on.
4.Replace the disabled load
with a new one.
1.To test the delay time
specified on either TIME1or
TIME2 knob and check
detector is nuisance
triggered if lighting device
does not turn off as the delay
time is up.
2.Keep away from detection
coverage to avoid activating
detector while doing the test.
3.Make sure load and wires
are connected correctly.
1.Walk in the effective
detection range ( Ø 6m).
2.Switch on the power.
3.Turn the knob to "Test".
4.Refer to wiring diagrams
(FIG.8 - FIG.9).
www.grupotemper.com