Genius Car Alarm 3B Serie Manual Del Usuario página 33

Genius Car Alarm
*To exit Anti-hijacking mode: APPLY THE DISARMING EMERGENCY PROCEDURE
AUTOMATIC ARMING
This function provides us with a greater confidence in our alarm, giving us security and
tranquility because of the alarm's complete protection.
With this function we can assure that the system will arm automatically in case we forget to
do so.
* For more security, it is recommended to arm the system with the remote control.
a. After turning the ignition key to ON position and closing the doors, 30 seconds later the
alarm will be automatically armed.
* See Jumper 1 selection for MANUAL / AUTOMATIC Arming
* See Programming Table for Automatic Arming Programming with doors lock.
AUTOMATIC REARMING
When the alarm is disarmed with the remote control, without turning the ignition key to ON
position and without opening the doors, 30 seconds later the alarm will be re-armed and
the doors will be locked.
CHANNEL 2 (TRUNK)
a. When the alarm is disarmed:
CHANNEL 2, BUTTON 4 FOR 3 SECONDS, the signal is triggered (The trunk will be
opened)
b. When the alarm is armed:
Activating channel 2, first the alarm will be disarmed and then the signal is triggered. (The
trunk will be opened)
* See Programming Table
CHANNEL 3
With this signal we can control a function (connecting an additional- optional module) such
as a window module, or the engine ignition.
Press buttons 3 and 4 together for two seconds to activate the function. (If the buttons are
pressed for more time, the signal is applied; releasing the buttons will stop the signal)
* See Programming Table
SECOND PULSE TO UNLOCK DOORS
If we wish to control the doors lock as AGENCY TYPE, with this function we can do it.
Disarming the alarm pressing the Button 2 once, only the driver's door will be unlocked. If
we press Button 2 again, within three seconds the others will be unlocked.
*See Programming Table
HORN OUTPUT
Normally, in alarms the sound is produced by a siren (Positive Output), with this new
system, we can simultaneously drive the horn's sound (Negative Output), or select one of
the two functions.
* See programming Table
VALET MODE
Valet, it is the function that allows us to cancel temporarily our security system, for those
situations in which we do not want to use the alarm system, for example in the car washer,
while in maintenance services, etc.
1. Valet by Remote Control
a. While the alarm is disarmed, press BUTTON 4 once. Within 3 seconds, press
BUTTON 3 for 2 seconds.
www.geniuscaralarm.com 33