Basement Sentry STBB100 Manual De Instrucciones página 9

INSTALLATION INSTRUCTIONS
12. Connect system wires to the controller on the
top of the battery box lid.
a. Plug the pump wire into the port marked
'PUMP'.
b. Plug the float switch wire into the port
marked 'FLOAT'.
c. Plug the 12V charger into the port marked
'ADAPTER'. Plug the charger into a 115V
GFCI protected power source.
Once the charger is plugged in, the LED lights
on the battery box should turn on.
13. Test DC pump operation by lifting up the DC
float switch and holding it in place. The pump
'Pump Status' LED will show a continuous light
and the alarm will beep steadily. The pump
should start at this time. If it doesn't start, check
all connections.
NOTE: The pump will continue to run for an
additional 10 seconds after the float has been
lowered. The alarm will continue to sound while
the pump is working.
14. Test all system connections by pressing the
'RESET' button for 1 - 4 seconds. The alarm
will sound. This will cause the system to run
a self-test and the DC pump will run for 3
seconds.
To silence the alarm, press the 'RESET' button,
hold for 4 - 8 seconds and release. The alarm
should stop.
After the system returns to normal status, the
alarm will automatically reset.
12
13
14
9
© 2020. All rights reserved.
FLOAT
ADAPTER SWITCH PUMP
Pump Status LED
Red light on and alarm sounds:
Battery backup pump working
Red light slow flash and alarm sounds:
Pump wire connection problems or pump failed
Yellow light on:
Battery recharging
Yellow light slow flash and alarm sounds:
Power off or power adapter failed
Yellow light quick flash and alarm sounds:
Battery disconnected or DC fuse broken
RESET
Green light on:
System is normal
Red light on and alarm sounds:
Battery backup pump working
Red light slow flash and alarm sounds:
Pump wire connection problems or pump failed
Yellow light on:
Battery recharging
Yellow light slow flash and alarm sounds:
Power off or power adapter failed
Yellow light quick flash and alarm sounds:
Battery disconnected or DC fuse broken
RESET
Green light on:
System is normal
Press Reset
SW1401 A
SW1401 A