Modecor Decojet A4 elite Manual Del Usuario página 49

Tabla de contenido

Publicidad

Each machine must bear, legibly and indelibly, at least the following particulars
• name of manufacturer
• the CE marking
• designation of series or type
• where appropriate, the serial number
(**) Framework Regulation 1935/2004 MATERIALS AND OBJECTS INTENDED TO
COMBAT FOOD PRODUCTS
ARTICLE 3 (EC Regulation 1935/2004)
General requirements
1. Materials and articles, including active and intelligent materials and articles, shall be manufactured
in compliance with good manufacturing practice so that, under normal or foreseeable conditions of
use, they do not transfer their constituents to food in quantities which could:
(a) constitute a danger to human health;
(b) bring about an unacceptable change in the composition of the edible product; or
(b) bring about an unacceptable change in the composition of the food;
or
(b) bring about an unacceptable change in the composition of the food; or organoleptic characteristics.
2. The labelling, advertising and presentation of a material or article shall not mislead consumers.
(***) REGULATION (EU) No 10/2011 on plastic materials and articles intended to come into
contact with food
ARTICLE 4
Placing on the market of plastic materials and articles
Plastic materials and articles may be placed on the market only if they
(a) in compliance with the relevant requirements set out in Article 3 of Regulation (EC) No 1935/2004
under the intended and foreseeable conditions of use;
(b) comply with the labelling requirements laid down in Article 15 of Regulation (EC) No 1935/2004;
(c) comply with the traceability requirements laid down in Article 17 of Regulation (EC) No
1935/2004;
(d) manufactured in accordance with good manufacturing practice as defined in Commission
Regulation (EC) No 2023/2006; and
(e) comply with the declaration and composition requirements set out in Chapters II, III and IV of
this Regulation.
The materials constituting the printer and the cartridges intended to come into contact with edible
products have been tested for overall migration and found to comply with the limits set out in Article
12 paragraph 1 of Regulation (EU) No 10/2011.
ARTICLE 12
Overall migration limit
1. Plastic materials and articles shall not release their constituents to food simulants in quantities
exceeding 10 mg of total constituents released per dm2 of food contact surface (mg/dm2).
elite
Decojet A4
49

Publicidad

Tabla de contenido
loading

Productos relacionados para Modecor Decojet A4 elite

Tabla de contenido