Connecting Speakers; Connecting The Antenna; Turning On The Power - Yamaha CRX-N470 Guía Rápida

PREPARATION
Supplied antenna
Right speaker
This unit
En
2
Secure using pins
Left speaker

◆ Connecting speakers

Speakers and speaker cables are not included with this unit. If connecting a subwoofer,
connect one with a built-in amplifi er to the [SUBWOOFER] on the rear panel.
CAUTION Use speakers with an impedance of at least 6 Ω.
1
Remove the insulation from the ends of the speaker cables to expose the
bare wires.
2
Connect the speakers to the unit as
shown in the fi gure at left.
Ensure that the left and right speakers
are connected to the left and right (L, R)
jacks respectively, and that the polarity of
the wires is correct (red: +, black: –).
Be careful not to allow the right and left bare speaker wires to touch
CAUTION
each other or other metal parts. Doing so could damage this unit and
the speakers.

◆ Connecting the antenna

1
Connect the supplied antenna as shown in the fi gure at left.
2
Secure it with pins or other supports in the location with best reception.

◆ Turning on the power

After all the connections are
completed, turn on the power.
Plug the power cable into a
power outlet, and press .
• When the power of the unit is turned on for the fi rst time after
Note
purchase, the network settings preparation message (Share WiFi Set)
may appear, but this message disappears as soon as any operations
are performed.
• For details on the network settings preparation message, see "Turning
on the power" in the Owner's Manual.
15 mm (5/8 in.)