SAME DEUTZ-FAHR iMonitor 2.0 Manual Del Conductor página 33

OPERATOR'S MANUAL
1.5.3 - Remote control valves
Access the function by pressing the "Hydraulic spool valves" control located on the right side of the display.
Hydraulic spool valves unlocked display page
1. Number and confi guration of spool valve controls.
2. Swap spools: allows the user to switch operation of the spool valves con-
trol, with any changes made displayed in the lower part of the screen.
3. Flow control setting:
Off: no mode enabled;
❍
Equalised: the oil fl ow is divided between all the spool valve controls
❍
according to demand;
Engine: engine revolutions are increased when the spool valve is
❍
actuated and an oil fl ow demand is present (max.1800 rpm);
Equalised + engine: the oil fl ow is distributed to the spool valves,
❍
and engine revolutions may be increased when required.
4. Icons describing any active functions
5. Maximum fl ow in both directions +/-
6. Time/mode
Proportional
❍
Timer-controlled
❍
Toggle
❍
Press the knob on the desired spool valve control to access the next screen which shows the status and settings of the selected
control.
Hydraulic spool valves setting screen
1. Spool valve control
2. BACK: returns you to the main SPOOL VALVES page
3. Current fl ow activation status of the spool valve
4. Maximum fl ow rate setting (in %) (+)
5. Maximum fl ow rate setting (in %) (-)
6. Spool valve operation time setting
7. Flow ratio lock
8. Disable fl oat position
9. Spool control switched from cab to fender
10. Spool valve priority setting
11. Lock applied to single spool valve control
12. Representation of the spool valves joystick operating curve
Hydraulic spool valves locked status display page
The spool valves can be locked by pressing the lock button on the multifunction
armrest in the tractor operator position. The status of the spool valves is displayed
with a specifi c lock icon (1).
Fig. 18
Fig. 19
Fig. 20
1-9