Maintenance; Cleaning - Maico EVN 15 Instrucciones De Montaje

gb │ 7. Installation
Fig. E: Electrically connect the unit,
 wiring diagram in Chapter 14
Danger to life from electric
shock.
Prior to access to the connection
DANGER
terminals switch off all supply
circuits. Switch off mains fuse,
secure against being accidentally
switched back on and position a
visible warning sign.
Danger of short-circuits
through incorrect feeding of
the power cable into the
CAUTION
terminal box.
Feed the power cable correctly
through the cable self-sealing
grommet and make sure there
is cable tension relief.
1. Make a circular hole in the self-sealing
grommet [11] and insert it into the
intended hole.
2. Connect the power cable to the terminal
block [12] as per the wiring diagram.
3. Fit tension relief [10].
4. Put the terminal box cover [4] on and
screw it into place.
5. Hang the internal housing [3] on the top of
the connecting flange [2] and clip it into
place in the safety catch. Do not twist it.
Fig. F: Only with EVN 15 P Fans:
1. Insert the pull-cord into the two housing
grooves.
2. Position the internal housing [3] as
described above.
Start-up
1. Switch the mains fuse on.
2. Carry out a function test.
12

8. Maintenance

The unit is maintenance-free.
With units installed in swivel
windows
Check the connection cable regularly for
signs of damage at the transfer point from
the window sash to the window frame.
If damaged, further operation of the unit is not
permitted. The unit must be disconnect from
the power supply (switch off the mains fuse
and secure it against being switched back on
again). Have the connection cable replaced
by a trained electrician.

9. Cleaning

Danger to life from electric
shock.
Prior to access to the connection
DANGER
terminals switch off all supply
circuits. Switch off mains fuse,
secure against being accidentally
switched back on and position a
visible warning sign.
Damage to the cover caused
NOTICE
by cleaning in a dishwasher.
Do not clean the internal housing
in a dishwasher.
1. Hold the internal housing [3] at the bottom,
on the right and left side and, pulling
equally on both sides, pull it forwards and
off.
Do not pull the internal housing [3]
off by the internal grille or the upper
edge.
2. Clean the internal parts with a dry cloth. If
necessary, use a vacuum cleaner. Swivel
the lamellae upwards to clean the shutter.
Do not use aggressive, harmful or
easily flammable cleaning agents for
cleaning work.
3. Attach the internal housing [3] ( Fig. E).