YATO YT-82152 Instrucciones Originales página 18

GB
Attention! Do not manipulate the mobile guard of the saw circular saw. All actions related to cutting must be realised holding the
sawing machine with both your hands.
Lead the sawing machine along the cutting so that the base of the sawing machine is touching the surface of the processed object.
If the saw jams in the material being processed, turn the sawing machine off immediately, pressing the lock button and the switch,
and only then remove the sawing machine from the kerf. During cutting pay particular attention to the possibility of slipping or
recoil of the sawing machine, and beware of dangers that may lead to accidents. During work do not exert excessive pressure on
the processed material and do not make rapid movements so as not to damage the circular saw and the sawing machine. Make
regular breaks during work.
Avoid overloading the tool – the temperature of the external surfaces must not exceed 60 C.
o
Once the task has been concluded, turn the sawing machine off , remove the plug of the tool from the mains socket and inspect the
machine.
The declared total value of vibration has been determined by means of a standard measurement method and may be used to com-
pare the tool with another one. The declared total value of vibration may be used for an initial evaluation of exposure.
Attention! The vibration caused during work with the tool may diff er from the declared value, depending on the way in which the tool
is used.
Attention! It is required to determine safety measures to protect the operator, based on evaluation of exposure under actual circum-
stances of operation of the machine (including all the phases of the working cycle, for example the time when the tool is off or is idling,
and the activation time).
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
18