Setting The Power Regulator - Ingersoll Rand 211 Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
POWER REGULATOR
Model 211 Impact Wrench is equipped with a regulator
that proportions power in both directions simultaneously
and equally. The power output is calibrated by stamped
numbers "1" through "5".
Model 212 Impact Wrench is equipped with a
combination power regulator/reverse valve designed to
provide power adjustment in the forward direction while
maintaining full power in the reverse direction. The
power output is calibrated by stamped numbers "1"
through "5".

SETTING THE POWER REGULATOR

Power Adjustment for Model 211
Rotate the Power Regulator (11) so that one of the
numbers on the Power Regulator aligns with the indicator
mark on the rim of the Swivel Inlet Body (8).
The power of the 211 is now adjusted for both directions.
This adjustment will not change regardless of how many
times you shift the Reverse Lever as long as you do not
change the power selection.
Power Adjustment for Model 212
The Model 212 Impact Wrench incorporates a power
regulator into the reverse mechanism that allows the
operator to have either full power output in one direction
and reduced power output in the other direction or full
power output in both directions. To adjust the power,
proceed as follows:
For full power in both directions, rotate the Reverse
Valve (25) until the notch on each end of the Reverse
Valve aligns with the number 5 on each side of the
housing.
The numbers 1 thru 5 on the
housing are only for reference
and DO NOT denote a specific
power output. One (1)
designates the lowest power
output while five (5) denotes
the highest.
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
620 kPa) Maximum air pres-
sure.
ADJUSTMENTS
(Dwg. TPD1247)
WARNING
WARNING
WARNING
International Warning Label:
Order Part No. ___________
For reduced power in the forward direction and full
power in the reverse direction, push the reverse valve
inward on the right side of the tool and rotate the reverse
valve until the notch on the right side aligns with the
desired number on the right side. This provides reduced
power in forward but full power in reverse when the
reverse valve is pushed in the opposite direction.
See Dwg. TPD1248.
For reduced power in the reverse direction and full
power in the forward direction, push the reverse valve
inward on the left side of the tool and rotate the reverse
valve until the notch on the left side aligns with the
desired number on the left side. This provides full power
in forward but reduced power in reverse when the reverse
valve is pushed the opposite direction.
See Dwg. TPD1249.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
(Dwg. TPD1248)
(Dwg. TPD1249)