Adding Oil To The Engine - Toro 58603 Manual Del Operador

11. Install the handlebar assembly and adjust
the height as desired; refer to
Handlebar Height (page
Figure 11
1. Nut—M6 (2)
2. Wire harness connectors
12. Connect the 2 wire harness connectors.
13. Install the drag stake.
Figure 12
1. Drag stake
Adjusting the
13).
g361870
3. Bolt—M6 x 65 mm (2)
g361869
2. Lock pin
2

Adding Oil to the Engine

Parts needed for this procedure:
1 Engine oil
Procedure
1. Move the machine to a level surface.
2. Remove the dipstick.
1. Filler tube
2. Dipstick
3. Slowly add oil into the filler tube until it is
overflowing.
4. Install the dipstick and tighten it.
9
Figure 13
3. Upper limit
4. Lower limit
g360549