Pre-Maintenance Procedures; Preparing For Maintenance; Lubrication; Greasing The Machine - Toro 58603 Manual Del Operador

Pre-Maintenance
Procedures

Preparing for Maintenance

1. Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark
plug.
Figure 23
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important:
Before tipping the machine,
allow the fuel tank to run dry through normal
usage. If you must tip the machine prior to
running out of fuel, use a hand fuel pump to
remove the fuel.

Lubrication

Greasing the Machine

Grease type: White lithium grease
Grease the machine at the following locations:
•
Forward and reverse arm assemblies
•
Forward and reverse engagement levers
•
Forward and reverse cables.
g361695
18