Altair AL-2781 Instrucciones página 5

3. Lay the HOOD onto the CAGE and secure it in place using the HOOD
All manuals and user guides at all-guides.com
SCREWS, as shown ( Attention:first screw a CAGE SCREW into the thread
hole on the CAGE to connect it with HOOD, then screw the other CAGE
SCREW into the hole without thread on the CAGE to connect it with HOOD).
Simultaneously, pull the fixture wires out the backside of the fixture, as
shown. (Fig. 2)
HOOD
CAGE
CAGE
SCREW
4. Thread the FIXTURE MOUNTING SCREWS into the provided holes of the
MOUNTING BRACKET, as shown. Thread the HEX NUTS onto the
FIXTURE MOUNTING SCREWS, as shown. Do not tighten the HEX NUTS
at this time. (Fig. 3)
5. Pull the power supply wires out from the OUTLET BOX, and attach the
MOUNTING BRACKET to the OUTLET BOX, using the BRACKET
MOUNTING SCREWS. (Fig. 3)
6. Strip approximately ¼" of insulation from each supply wire from the OUTLET
BOX. Raise the MAIN FIXTURE BODY to the wall, bringing the WALL
PLATE close to the OUTLET BOX. Make the following wire connections
using the WIRE NUTS (Fig. 3):
WHITE (NEUTRAL) SUPPLY WRE
BLACK (HOT) SUPPLY WIRE
TWO SUPPLY GROUND WIRES
7. Place the WALL PLATE over the OUTLET BOX, making sure the FIXTURE
to WHITE FIXTURE WIRE
to BLACK FIXTURE WIRE
to FIXTURE GROUND WIRE
Page 5
Fig. 2