Altair AL-2781 Instrucciones página 6

MOUNTING SCREWS feed through the holes on the WALL PLATE. Adjust
the FIXTURE MOUNTING SCREWS until they protrude out from the WALL
PLATE ¼".
FIXTURE MOUNTING SCREWS by tightening the HEX NUTS against the
MOUNTING BRACKET. (Fig. 3)
8. Carefully tuck all WIRES and WIRE NUTS into the OUTLET BOX. Place the
WALL PLATE back onto the FIXTURE MOUNTING SCREWS, and secure it
into place using the LOCK NUTS. (Fig. 3)
LOCK
NUT
Wrap each wire connection with 2" of electrical tape.
9. After installing the fixture, caulk the upper 2/3s of the WALL PLATE to the
mounting surface. Leave the bottom 1/3 un-caulked to allow for drainage of
any water that might leak into the enclosure.
recommends a non-drying exterior caulking material. A good example is a
clear silicone rubber sealant for exterior use.
10. RESTORE POWER AT THE CIRCUIT BREAKER. Turn on the wall switch.
All manuals and user guides at all-guides.com
Remove the WALL PLATE and secure the position of the
BRACKET
FIXTURE
MOUNTING
GROUND
SCREW
WIRES
HEX
NUT
BLACK
FIXTURE
WIRE
WHITE
FIXTURE
WALL
WIRE
PLATE
FIXTURE
MOUNTING
SCREW
MOUNTING
BRACKET
SUPPLY
GROUND
WIRE
WRE
NUT
Page 6
OUTLET
BLACK
BOX
(HOT)
SUPPLY
WIRE
WHITE
(NEUTRAL)
SUPPLY
WRE
Fig. 3
The manufacturer