Before You Begin; Assembly And Installation - Altair AL-2781 Instrucciones

CAUTION:
•
All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards.
electrical practices, obtain services of a qualified electrician.
•
Turn off the main power at circuit breaker before installing fixture, in order to
prevent possible shock.
•
Before replacing light bulb or cleaning fixture, turn off power and allow
several minutes for the fixture to cool down.
•
Pull the PLUG from the SOCKET when replacing dead light bulb or driver
and push the PLUG into SOCKET when replacing new light bulb or driver.

BEFORE YOU BEGIN:

•
This fixture has a photocell light control located on the backside of the hood.
The LED lights will turn on when the ambient light around the photocell has
diminished to a nighttime light level.
ambient light has risen back to a daylight level. Avoid installing the fixture
near nighttime light sources, such as street lights or other light fixtures, which
might prevent the light from turning on.
•
The OUTLET BOX described in the following section is not provided. To
install this fixture, a standard OUTLET BOX needs to be pre-installed in the
ceiling at the selected mounting location. Power supply wires need to be run
to the OUTLET BOX providing 120 VAC of power. If an OUTLET BOX does
not exist, contact a qualified electrician to have one installed.

ASSEMBLY AND INSTALLATION:

1. DISCONNECT POWER AT THE CIRCUIT BREAKER.
2. Slide the GLASS SHADE into the CAGE. (Fig. 1)
GLASS
SHADE
CAGE
All manuals and user guides at all-guides.com
If you are unfamiliar with proper
The lights will remain on until the
Page 4
HOOD
Fig. 1