Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT NOTICE ABOUT LEAKING BOTTLES
If you find that your dispenser is leaking, check the water bottle first!
Almost all 3 and 5 gallon water bottles are recycled, and handled extensively during cleaning, filling,
and shipping. As a result they are very prone to developing pin holes or small cracks that can cause an
overflow (or leak) when placed on top of a water dispenser.
In almost all cases, there is nothing wrong with your water dispenser. If you
are experiencing a leak, this simple test will allow you to determine whether
your water bottle or dispenser is the source of the problem.
1. Unplug the unit, turn off power switch and remove the water bottle.
2. a) Remove the bottle support collar and check the water level inside
the reservoir – it should be at roughly three-quarters full.
b) Please add or drain a few glasses of water to achieve the required
fill level. Water level should be approximately 3/4" – 1" BELOW
VENT TUBE.
3. Let the water sit for approximately 2 hours. If the dispenser does not
leak, it is the bottle that is leaking due to a small crack or pinhole.
Please contact your water supplier for a replacement bottle.
Please visit us at www.greenwayhp.com for water dispenser
accessories and helpful use and care tips.
Dispensing Room and Cool Water
Place a glass under the spigot. For cool water, press the
water is dispensed. Before the Insta-HOT feature is activated, the
temperature water. To dispense room water, press the
of water is dispensed. (For hot water, see Dispensing Hot Water).
Temperature Setting
The water temperatures are factory set and cannot be adjusted.
4
All manuals and user guides at all-guides.com
1.
2.a
2.b
Vent Tube
Water Level
button until the desired amount of
button dispenses room
button downward until the desired amount
Publicidad
Tabla de contenido
