FLAEM LightNeb Manual De Instrucciones De Uso página 25

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 79
1A
PUSH
5
2
4
3
6.1.2 DRYING:
6.1.2.a After washing and rinsing all the com-
ponents, shake them to remove excess water
and reassemble them as described in the fol-
lowing paragraph DEVICE REASSEMBLY.
At this point, to eliminate the water deposited
in the nebulisation and mesh cup (2), press key
1A (figure opposite) and wait for the device to
stop nebulising. Then switch off the unit.
WARNING This operation is very important be-
cause it avoids limescale deposit in the mesh
microholes, which could compromise the cor-
rect nebulisation in the subsequent therapeu-
tic application.
6.1.2.b To complete the drying of all compo-
nents, leave them in the open air and in a dry
place (e.g. not in the bathroom) as shown in the
figure opposite.
6.2 CLEANING Device Body
Use a cloth lightly moistened with antibacterial
detergent to clean the Device Body (1).
Then dry it with a soft paper towel.
WARNING
Do not immerse the Device Body (1) in water
and do not wash it under running tap water.
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P0318emMf32e00

Tabla de contenido