Prepare The Battery - Lampa TURBO 2 Instrucciones Para El Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

BATTERY CHARGER
CAUTION BEFORE STARTING
TO CHARGE
It is absolutely mandatory to follow all
the instructions and cautions given by
your car manufacturer concerning the
battery charging.
If not stated, we suggest you to com-
pletely disconnect the battery from
the car before charging it in order for
the elechtronical parts not to get ex-
posed to damages.
Black
Clip

1. PREPARE THE BATTERY

Remove all the stoppers from the elements of the
battery.
Check the level of the acid inside of every single ele-
ment and if necessary, put some distilled water in
order to bring them to the required level. Pay atten-
tion not to make the acid leaking.
Put the stoppers back on the elements only after
having fully charged the battery. The gas that is
produced while charging must evaporate.
NOTE: with sealed batteries it is not necessary to remove the stoppers
from the elements nor to put some distilled water.
Red
2. CONNECTION
Clip
First connect the positive clip + (RED colour) of the
battery charger to the positive pole (+) of the batte-
ry, then connect the negative clip – (BLACK colour)
of the battery charger to the negative pole (-) of
the battery. Check that all the clips are connected
properly.
3. CHARGE
Connect the plug of the battery charger to the
socket (220/240Volt). After plugging, the battery
charger will start immediately to work. Charging is
complete when all LEDs are ON.
NOTE: when a fully discharged battery is connected to the battery char-
ger, the voltage and the charge resistance are low, therefore the battery
will charge more rapidly. Then, if you increase both voltage and resistan-
ce, the charge speed will decrease.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Turbo 6Turbo 8Turbo 12701047010670108 ... Mostrar todo

Tabla de contenido