Metabo HPT DS 18DBL2 Manual De Instrucciones página 18

English
13. About Remaining Battery Indicator
Remaining battery power can be verifi ed by pulling on
the switch to light up the remaining battery indicator
lamp. (Fig. 20)
The indicator lamp will turn off 10 seconds after the
switch is released.
The Table 10 shows the state of remaining battery
indicator lamp and the battery remaining power.
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Display panel
Remaining battery
indicator lamp
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
14. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 21)
The LED light will automatically turn off 10 seconds
after the switch is released.
The LED light also functions as a warning signal that
lights up during use.
For details, see "17. LED light warning signals".
18
Table 10
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
Switch trigger
Fig. 20
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
15. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When electing to carry the tool hooked to your
hip belt, make sure to detach the tool bit and side
handle.
Failure to do so may result in unexpected injury.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 22)
Switch trigger
Fig. 21
Groove
Screw
Hook
Fig. 22