Cutting Warped Material - Ryobi P552 Manual Del Operador

Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
33.85°
2. Miter table set right 31.62°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
33.85°
2. Miter table set left 31.62°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
33.85°
2. Miter table set left 31.62°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
33.85°
2. Miter table set right 31.62°
3. Save right end of cut

CUTTING WARPED MATERIAL

See Figures 32 - 33.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 32.
If the warped material is positioned the wrong way as shown
in figure 33, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
All manuals and user guides at all-guides.com
OPERATION
26 – English
RIGHT
WRONG
Fig. 32
Fig. 33