Parts And Diagram List - CleanForce CF1400 Manual De Instrucciones

PARTS AND DIAGRAM LIST

A
B
C
D
Item No. Quantity Part Name
A 1 Adjustable wand
B 1 Spray gun
C 1 High-pressure hose
*
D 1 Water filter
E 1 Upper handle
F 1 Detergent tank assembly
G 1 Lower handle
H 1 Hose bracket
I 1 Gun holder
Power cord bracket
J 1
K 1 Needle (for nozzle cleaning)
* Water filter come pre-attached on the water inlet, located on the front of the pressure washer.
5 English
ASSEMBLY AND OPERATING INSTRUCTIONS
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
E
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
F
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Garden hose must be
G
at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM
H
(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running
the
temperature must not exceed 104°F (40°C).
I
J
Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
Dirt in the water inlet will damage the unit.To avoid this risk, we recommend checking
the water
Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water
K
To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.
1
Attach gun holder and power cord bracket.
water for one minute into an empty 5-gallon (19 L) container The water supply
CAUTION
(located inside the water inlet.To clean it out see Maintenance section).
.
if required.
2
Place the upper handle into the recesses
and push forward until it audibly locks in.
English 6