Assembly And Operating Instructions; Using The Accessories; Working With Detergents - CleanForce CF1400 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND OPERATING INSTRUCTIONS

USING THE ACCESSORIES

Jet
Fan
Adjustable Spray Nozzle
The adjustable spray nozzle can be adjusted from fan to jet. The spray is adjusted from jet
to fan spray by turning the nozzle.
CAUTION
Jet spray adjustment is very strong. Do not adjust whi le spra ying.

WORKING WITH DETERGENTS

Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more effectively. Always spray detergent on a dry
its cleaning ability.
To apply detergents you must be operating at low-pressure. This provides a gentle applica-
tion of detergent, with the pressure equivalent to a lowest garden hose. The high-pressure
setting is used for cleaning; you cannot apply detergents when working at high-pressure.
Always test detergent in an inconspicuous area before use.
NO BLEACH
CAUTION
Only
use cleaning detergents recommended for pressure washers.
1
Engage gun safety lock.
9 English
2
+
-
Set the adjustable wand to the low-
pressure setting by pulling the nozzle out.
The wand must be set in the low-pressure
position to apply detergent.
ASSEMBLY AND OPERATING INSTRUCTIONS
3
Gently pull detergent container out of storage position, and fill with detergent. Push
container back into storage position.
4
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-
cally mix with water, and be discharged through the nozzle at low pressure. Apply detergent
to a DRY work surface, from bottom to top.
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
5
detergent to dry on surface.
Rinse with clean water under high pressure. On a vertical surface, rinse from the
6
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8" (15-20
cm) from the work surface, at a 45° angle.
7
with clean water. Siphon water at low pressure for one minute, so that all detergent is
CAUTION
Damage may occur to painted surface if chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.
English 10

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para CleanForce CF1400

Tabla de contenido