Sanus Systems VMPR1 Instrucciones De Ensamblaje página 7

Idiomas disponibles

Step 3A: Attach Ceiling Plate to Adjustment Bracket - Flat Ceilings

NOTE: If the projector is being mounted in an area where it must be lower from the ceiling, such as areas with vaulted

or cathedral ceilings, proceed directly to Step 3B - Attach Ceiling Plate to Adjustment Bracket using Extension Pipe

and NPT Adapter - Vaulted or Cathedral Ceilings.

Place the Ceiling Plate (C) over the Adjustment Bracket (D), lining up the holes in both the Ceiling Plate and the Adjustment

Bracket as shown in Diagram 3A; then, using the two Cap Screws (I) secure the Adjustment Bracket to the Ceiling Plate.

Using the Allen Key (V) and the two Cap Screws (I), secure the Ceiling Plate (C) to the Adjustment Bracket (D).

Step 3B: Attach Ceiling Plate to Adjustment Bracket using Extension Pipe and NPT Adapter - Vaulted or Cathedral Ceilings

Place the Ceiling Plate (C) over the NPT Adapter (E), lining up the holes in both the Ceiling Plate and the NPT Adapter as

shown in Diagram 3B.

Using the Allen Key (V) and the two Cap Screws (I), secure the Ceiling Plate (C) to the NPT Adapter (E).

NOTE: Set Screw (J) is shorter than Set Screw (N).

NOTE: When using the NPT Extension Pipe (F), the Set Screw (N) must point either toward or away from the screen.

If a longer NPT Extension Pipe is required, custom lengths may be purchased from your local hardware store.

Thread the NPT Extension (F) into the NPT Adapter (E) and secure it with the Set Screw (J) as shown in Diagram 3B.

Thread the Adjustment Bracket (D) onto the NPT Extension (F); then, using Set Screw (N), secure the Adjustment Bracket

(D) to the NPT extension (F) as shown in Diagram 3B.

Diagram 3A

Diagram 3B