Uline H-9446 Manual Del Usuario página 2

3. Attach opposite ends of two outer cross bars and
center cross bar to remaining upright using three
M12 x 55 mm hex bolts. Tighten with adjustable
wrench. (See Figure 3)
Figure 3
4. Attach reinforcement brace to upright and bracket
on center cross bar on a diagonal using two
M6 x 45 mm hex bolts and two M6 x 11.25 mm hex
nuts. Tighten with wrench and pliers. Repeat on other
side. (See Figures 4a-4b)
Figure 4a
Figure 4b
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
5. Attach top cross bar to top of uprights using
TO LOAD STAGES ON DOLLY:
1. With two people, tilt top of stage slightly downward
2. Aligning bottom of stage onto bottom of dolly,
1-800-295-5510
uline.com
remaining two M12 x 55 mm hex bolts. Tighten with
adjustable wrench. (See Figure 5)
Figure 5
and rotate latch toward center of dolly.
place stage down and secure into desired position.
Release latch into original position to prevent stages
from falling off dolly. (See Figure 6)
Figure 6
0421 IH-9446