Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Do not remove side mulching plug at any time, even
when you are not mulching.
Adjustments
1.
The cutting height adjustment lever is located above the
rear left wheel. See Fig. 3-7.
a.
Pull the lever out and away from the mower.
b.
Move the lever forward or back for desired cutting
height.
c.
Release lever towards mower deck.
WARNING:
adjustment to lawn mower without first stopping
motor and removing key.
10
s
3 — a
ectiOn
sseMbly
B
A
C
Figure 3-7
Do not at any time make any
& s
-u
et
p
Set-Up
Charging the Battery
WARNING:
The battery contains corrosive fluid
and toxic material - HANDLE WITH CARE. Keep away
from children. Do not puncture, disassemble,
mutilate, or incinerate. Explosive gases could be
vented during charging or discharging. Use in a well
ventilated area, away from sources of ignition.
Charge the mower for 14 hours before initial use. Charge
mower indoors in a dry area out of the weather. DO NOT charge
in rain or wet locations.
IMPORTANT: Use only the battery charger provided with this
mower (Part number 725-04387).
Plug the battery charger into the mower first, and then into any
standard 110/120 volt household electrical outlet. See Fig. 3-8 for
battery charging location on mower.
Figure 3-8
NOTE: If an extension cord is required, use one that is at least
wire size 16 AWG. Connect the extension cord to charger before
plugging extension cord into electrical outlet.
IMPORTANT: Always recharge mower fully. It takes 14 hours to
recharge a completely discharged battery. A flashing light on the
battery charger indicates battery is charging; a solid green light
indicates battery is fully charged. A full charge will be achieved in
less than 14 hours if the batteries were only partially discharged.
NOTE: It is recommended that the mower be charged once every
two months during storage.
IMPORTANT: Always disconnect battery charger (or extension
cord, if used) from the electrical outlet first, then disconnect
battery charger from mower.
Overload
Protection
Switch

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

18a-188-71018a-188-756

Tabla de contenido