After Use; Cleaning And Storage - Holmatro BCU 05 A Serie Manual

• Close the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
6.6

After use

6.6.1 Inspection
• Check the battery level. Recharge the battery pack, if necessary. See section 3.6.
• Check the unit for completeness, leaks and damage. Do not use the unit if it leaks or is damaged
and contact the Holmatro dealer.
• Check the accessories used for completeness and damage. Replace them if the damage is
considerable.
• Inspect the tips. Replace them if the damage is considerable.
• Check the operation of the deadman's handle. It must return to the neutral position when you
release it.
• Check that the carrying handle is firmly attached.
6.6.2 Storing the battery pack
NOTICE
When the battery pack is not in use, it is advised to keep the battery pack connected to the
battery charger (connected to a power source) at all times. When the battery pack is full, the
battery charger automatically switches on and off at regular intervals to keep the battery
level at 100%.
• Store the battery pack in a dry and well-ventilated area. The maximum storage temperature (see
section 3.4) may not be exceeded.
• Make sure the equipment can not fall over during transport.
6.6.3 Shut down
• Close the blades with the blade tips over each other to prevent injury. Do not fully close the blades
so that the tool can be stored without pressure.
• Switch the tool off.
• Remove the battery pack and place it in the battery charger.
6.6.4

Cleaning and storage

• Clean the tool and any accessories before storage.
• Dry the tool if it was used in wet conditions. Apply a thin coat of preservative oil to the external steel
parts.
• Store the tool in a dry and well-ventilated area.
BCU * A *
All manuals and user guides at all-guides.com
916.400.018_003
EN
43