Dremel VersaTip 2000 Instrucciones De Funcionamiento página 8

DM 2610Z06356 05-14 copy_2000 5/7/14 11:47 AM Page 8
Using with an Open Flame
When configured for open flame, the
VersaTip can be used for tasks such as
culinary caramelizing, brazing, copper pipe
sweating, and freeing of seized nuts and
bolts.
To use the Dremel VersaTip with an open
flame, unscrew the flame guard, remove the
flame diffuser and tip (if attached), screw the
flame guard back onto the tool, and securely
tighten the flame guard nut.
Using with Soldering Tip
The soldering tip (to be used with the flame
diffuser) can be used for regular soldering
activities, including joining wire and
component installation on printed circuit
boards.
Using with Hot Air Tip
The Hot Air Tip (to be used with the flame
diffuser): can be used for heating of heat-
sensitive materials.
The hot air tip generates air temperature of
1256°F (680 °C)
Applications
Using with Cutting Knife
The Cutting Knife (to be used with the flame
diffuser) can be used for cutting of nylon rope
to prevent 'feathering'.
Using with Shaping Knife
The Shaping Knife (to be used with the flame
diffuser) can be used for cutting to size of
sheets of plastic and other heat sensitive
materials.
Using Wide Tip Blower
The Blower can be used for preparing
surface areas for detailed paint and coating
removal.
Use with Deflector
The Deflector (to be used with the flame
diffuser) is for shrinking of heat sensitive
insulation around electrical wiring.
Follow instructions provided with
materials being used and worked on.
-8-