Craftsman 919.155190 Manual Del Usuario página 10

All manuals and user guides at all-guides.com
Operating Tips
• To reduce overspray and obtain
maximum efficiency, always spray
with the lowest possible fluid/air
pressure.
• Hold the gun perpendicular to the
surface, 4" to 6" distance.
• Two thin coats will produce a
better finish than one heavy coat.
• Mask off areas not being
sprayed.
• Follow contour.
• Overlap each stroke 50%.
• Ends are feathered by triggering.
That is, begin stroke before
pulling trigger and releasing just
before ending the stroke.
• Spray edges and corners first.
This will reduce overspray while
providing good coverage on
corners.
Correct Spraying
4-6 inches
Start
Pull
Stroke
Trigger
Incorrect Spraying
coating will be
light at this point
D29783
• Don't arc strokes, move the gun
parallel to work.
• Pattern should be
shaped as shown, if not
see "Troubleshooting"
section.
• Care should be exer-
cised when handling spray gun to
avoid damage to the orifice of the
air cap and tip of fluid nozzle.
Damage to these parts results in
irregular spray patterns.
• Practice on a cardboard target to
make sure pattern size and
material consistency are correct
before spraying on actual project.
Coating should be even
and wet when spraying
coating will be
heavy at this point
10- ENG
End of
Release
Stroke
Trigger