Craftsman 919.155190 Manual Del Usuario página 9

All manuals and user guides at all-guides.com
USE OF A FACE
MASK IS
RECOMMENDED TO PREVENT IN-
HALATION OF TOXIC MATERIAL.
Before Using Your Spray
Gun
1. Set up spray gun as described
in the "How to Set Up Spray
Gun" paragraph in the
"Assembly" section of this
manual.
To Use Spray Gun
1. The position of the air cap horns
will determine the fan spray
pattern. Loosen air cap and rotate
horns to achieve desired pattern.
Tighten air cap.
Horizontal position
Vertical position
2. Turn fluid control knob clockwise
until it stops, do not force. This
will shut off the fluid flow. NOTE:
The fluid or density of "fan spray"
is controlled by fluid control
knob.
3. Turn pattern control knob
counterclockwise until first thread
is flush with gun body. NOTE: Air
flow is controlled by pattern con-
trol knob.
DO NOT turn pattern
control knob or fluid
control knob counter clockwise after
first thread is flush with the gun
body. They are under pressure when
the gun is triggered and could leave
the gun with force.
first thread flush
4. Turn air valve control knob
clockwise until it stops, do not
force.
5. Adjust air pressure to 40 psi at
regulator.
viscosity of material used. Maximum
working pressure of gun is 45 psi.
DO NOT EXCEED PRESSURE LIMIT
OF GUN OR ANY OTHER COMPO-
NENT IN SYSTEM!
6. Depress spray gun trigger and
gradually turn the fluid control
knob counterclockwise until
desired fluid flow is reached.
Trigger gun quickly, one second
on-off to test pattern.
other person. Accidental discharge
of material may result in serious
injury.
To adjust spray pattern and fluid
pressure:
• To adjust the fluid, turn fluid con-
trol knob counterclockwise to in-
crease or clockwise.
• To adjust the air flow, turn pattern
control knob counterclockwise to
increase or clockwise to de-
crease.
Pattern
• To fine tune the air flow, turn air
Control
valve control knob counterclock-
Knob
wise to increase, or clockwise to
decrease.
Fluid
IMPORTANT: Always clean gun after
Control
each use. See "Maintenance" section
Knob
for correct procedure.
9- ENG
Air
Valve
Control
Knob
DO NOT exceed 45
psi.
Pressure may vary
according to
NEVER point spray
gun at self or any
D29783