Important - Craftsman 919.155190 Manual Del Usuario

IMPORTANT: The use of a oil/water extractor is recommended. See set
illustrations for examples.
Basic Set Up
Ideal Set Up
Air Inlet
Before Using Spray Gun
This gun is designed
for use with most
finishing materials. It is not
designed for use with corrosive or
highly abrasive materials. Using
these materials can lead to poor
performance and/or failure of this
product.
1. Mix material according the
manufacturer's instructions.
Mixture should be smooth and
easily pourable. Lumps or foreign
particles should be removed by
straining through a suitable paint
filter. NOTE: Using a Sears
Viscosimeter will help in
measuring the viscosity or
thickness of the material.
For Siphon Feed Connection
1. Remove the material cup from
lid/gun assembly. NOTE: Slide
release lever to the right, rotate
lid, and remove material cup.
D29783
All manuals and user guides at all-guides.com
Air Inlet
2.
3.
NOTE: When replacing lid/gun
assembly make sure bend in material
tube is positioned to the front of the
spray gun as shown.
4.
5.
6- ENG
To Air Supply- an
air compressor
equipped with a
regulator
Recommended
oil/water extractor
Regulator and
oil/water extractor
Fill the material cup 3/4 full.
Attach material cup to the lid/gun
assembly and slide release lever
to the left to secure in place.
Bend
Attach air supply line to 1/4 NPT
air inlet.
See "Operation" Section to learn
how to use the spray gun.
To air supply -
hard plumbed
air supply
D29783