Chapter 4: The Tape Player; Playing A Tape - Sony MHC-V700 Manual De Instrucciones

Chapter 4:
the Tape
Player

Playing a Tape

Recording a CD
Recording a CD: Specifying
Tape Length (time edit)
Recording From the Radio
Recording From Another
Tape (dubbing)
Playing a Tape
You can use TYPE I (normal), TYPE II
(CrO ) and TYPE IV (metal) tapes. When
2
you insert a tape, the deck detects the tape
type automatically.
POWER m ON
2
3
1
0 ) 0 )
p p
DOLBY NR
DECK A ª ·
DECK B ª ·
1
Press § EJECT to open tape
compartment.
Insert a recorded tape in deck A or B
with the tape side down and the side
you want to play facing forward. Push
to close the compartment. The tape will
start playing from the front side.
Playing side facing forward
2
Select dual or single-sided recording.
To play Press DIRECTION
to select
A
One side of the tape
ß
Both sides* 1
Both decks in RELAY
2
succession*
* 1 The deck stops automatically after
repeating the sequence five times.
2
* See "To play both decks in succession
(relay play)".
3
Press · (to play the front side) or ª
(to play the reverse side).
The tape starts playing.
To Press (on remote)
p
Stop play
P PAUSE (P)
Pause
(Deck B only)
P PAUSE (P) (Deck
Resume play after
B only), ª or ·
pause
) for front side
Fast forward
0 for reverse side
P
0 for front side
Rewind
) for reverse side
3
§ EJECT
Remove the cassette
1
Using the remote
1 Press DECK A ª · or DECK B
ª · during stop mode. The deck
starts playing the front side. Press again
to play the reverse.
2 Press the desired operation button.
To play both decks in succession
(relay play)
Relay play always follows the following
sequence. When the reverse side of the tape
in deck B finishes playing, the following
sequence continues four more times.
Deck A
(Front side) m
Â
Deck B
(Reverse side)
M
1 Press § EJECT and insert recorded tapes
in both decks.
2 Press DIRECTION repeatedly until
"RELAY" appears in the display.
3 Press ª or · on either deck.
To stop relay play, press p.
To cancel relay play
Press DIRECTION repeatedly until "A"
or "ß" appears in the display.
When listening to a tape recorded with the
Dolby* B-type noise reduction system
Press DOLBY NR button so that "DOLBY
NR B" appears in the display.
The setting affects both decks. Dolby noise
reduction system reduces tape hiss noise in
low-level high-frequency signals.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol a
are trademarks of Dolby Laboratories
Licensing Corporation.
continue to next page

Chapter 4: the Tape Player

EN
19
Deck A
(Reverse side)
µ
Deck B
(Front side)