Detachable Blower - Workshop WS0400DE1 Manual Del Usuario

DETACHABLE BLOWER

1. To remove the detachable blower
from the lid assembly: press down on
the detachable blower latch under
the detachable blower handle and lift
the blower off the lid of the Vac.
2. To replace the detachable blower
onto the lid assembly: position
detachable blower above the indented
area of the lid assembly. Rotate the
detachable blower down until the travel
of the unit stops.
3. Lightly press down on the carry handle
of the detachable blower until you hear
the "snap" of the detachable blower
latch engaging the detachable blower.
The detachable blower is now latched
to the lid assembly.
4. Your new Wet/Dry Vac is ready for use.
With the Wet/Dry Vac completely
assembled and ready for use, insert
the locking tab end of the hose into the
vac inlet port. The hose should snap
into place.
To remove the hose from the Vac:
press the hose locking tab and pull the
hose out of the vac inlet port, as shown.
(Removal and Installation)
Detachable
Blower
Detachable Blower
Carry Handle
Detachable Blower
Latch
Detachable
Blower
Lid Assembly
Detachable
Blower
Carry
Handle
Vac Inlet Port
Hose
Locking Tab
Hose
7
Indent
Area (2)