Operation - Klarstein KAMINI FXL 2G Manual Del Usuario

EN
20

OPERATION

Turn the power switch on the right side of the heater to the 'On' position. As soon
as power is supplied to the unit, a beeping sound will be heard. The power switch
supplies power to all functions of the unit. The switch must be in the 'I' position in
order to use all functions, including the remote control.
First switch the power switch on the right side of the device to the 'I'
position. As soon as power is supplied to the unit, a beeping sound
will be heard. The heating function and the flame effect are switched
off. The device is in standby mode. The display window shows 'OF'.
Power on: If you press the ON/OFF button on the remote control
once, you will hear a short beep and the unit will enter the operating
mode. The power indicator lights up and the heating function and
flame effect are switched on.
Power off: When you press the ON / OFF button on the remote
control, a beep will be heard and the device will turn off. The LED
lighting, the heating function, the flame effect and the power
indicator will go out. If the heating function was on, the fan of the
unit will continue to run for about 60 seconds after the unit is put into
standby mode.
Set the time until automatic switch-on:
When the unit is in standby mode, press the TIMER button once.
'00' is initially displayed in the display window. Each time you press
the TIMER button, an hour will be added: 00 - 01 - 02 - 03 ... - 24
- 00. Select the desired time after which the device should start
automatically. As soon as the time you have set has elapsed, the
device will switch on and 'OH' will be displayed in the display window.
The heating function runs at the highest level and the flame effect is
set to the brightest mode.
Set the time until automatic switch-on:
When the unit is in operating mode, press the TIMER button once.
'00' is initially displayed in the display window. Each time you press
the TIMER button, an hour will be added: 00 - 01 - 02 - 03 ... - 24 -
00. Select the desired time after which the device should shut off
automatically. As soon as the time you have set has elapsed, the
device will switch off. The fan will then continue to run for 60 seconds
to disperse the heat remaining in the unit. In the display window the
countdown is counted down: 60 - 59 - 58 ... .